– If the brake pedal feels spongy, perform the conventional brake bleed procedure again.ġ1.When the desired pedal height is achieved, press the brake pedal in order to inspect for firmness.ġ3.Install the tire and wheel assemblies.ġ5. (DTC) List and diagnose the appropriate DTC. – If a DTC is detected, refer to Diagnostic Trouble Code Sent from my iPhone using Tapatalk A alexdi Registered Joined 830 Posts 12 You're right, that worked fine. Perform the following steps before resuming the bleed procedure: The procedure is to push new oil up from the shock or fork separately and it doesn't push any bubbles back down the other hose if that's what you're asking. Select Automated Bleed from the Special Functions menu.ĩ.Follow the scan tool directions until the desired brake pedal height is achieved.ġ0.If the bleed procedure is aborted, a malfunction exists. Repair or replace as needed.Ħ.Turn ON the ignition, with the engine OFF.ħ.With the scan tool, establish communications with the EBCM. Refer to Brake Fluid Loss or Symptoms – Hydraulic Brakes. Failure to properly relieve pressure may result in spilled brake fluid causing damage to components and painted surfaces.ġ.Raise the vehicle on a suitable support.Ģ.Remove all four tire and wheel assemblies.ģ.Inspect the brake system for leaks and visual damage. After exiting the bleed procedure, relieve bleed pressure and disconnect bleed equipment per manufacturers instructions. No further Scan Tool prompts pertaining to the Auto Bleed procedure will be given. Notice:The Auto Bleed Procedure may be terminated at any time during the process by pressing the EXIT button.
0 Comments
Leave a Reply. |